1. Wipe the screen clean with the fiber cloth in the film bag
2. Stick the dust stick on the screen of the phone to stick the stubborn stains and dust to ensure the screen is spotless.
3. Take out the phone film and compare the hole position of the phone.
4. There are two labels on the protective film of mobile phone. First, tear off the no. 1 label and stick the protective film to the screen of mobile phone
5. Pay attention to the alignment hole and the edge of the phone screen, and try not to touch the use layer
6. After the whole protective film of the mobile phone is affixed to the screen, tear off the no. 2 label
7. Slowly scrape the air bubbles above the phone screen with the scratch card to expel the air
8. If there are bubbles on the screen that cannot be scraped off, you can stick the film together with the suction stick, check whether there is any dust stuck on the screen, and use the suction stick to stick off the dust
9, wipe the screen with a cloth, the whole cell phone film process is completed

Key points of film sticking:
1. Clean the screen thoroughly before laminating, especially don't leave dust.
2. After tearing the no. 1 release membrane, pay special attention to the finger can not touch the adsorption layer, otherwise it will affect the film effect.
3, in the process of sticking film, do not tear the 1 (1) from the membrane, should be torn, while sticking.
4. Make good use of the scraper card to drain bubbles.